Tinkerforge Sensor Bricklet: Motion Detectors
|Distribution:||official part of Check_MK|
This check monitors motion detector bricklets on any tinkerforge stack.
For this check the time ranges during which movement shouldn't occur
can be configured.
Outside these times, a motion would be mentioned in the infotext but
the state remains OK.
Please note that the sensor has two hardware "wheels" to control its
sensitivity and how long, after motion ended, the motion detector will
remain in its warning states.
check_mk can not influence these values.
The bricks position inside the stack.
One service is created for each motion detector bricklet.